On stucco, brick, or concrete, use a 1/4" (6mm) masonry bit to drill holes in your wall, then insert the included wall anchors. Using your Video Doorbell Wired as a template, mark the location of the two mounting holes on the wall. Gently pull the faceplate off the unit by pulling it from the lower edge of the plate. Make sure they don't fall back inside your wall, so you can access them later. Be sure to tighten the terminal screws.ħ. It doesn't matter which wire you connect to which terminal. Make sure to keep the existing doorbell wires in place.Ĭonnect one end of the Jumper Cable to the "Front" terminal, and the other to the "Trans" terminal. Loosen the "Front" and "Trans" terminal screws. Remove the cover from your doorbell chime.Īfter you've located your doorbell chime and turned off the power at the breaker, remove the cover from your chime and set it aside for now.ĥ. The AC connector is a class 2 energy source.Ĥ. Your Video Doorbell Wired is compatible with doorbell systems supplying 10-24 volts AC, at 50 or 60 Hz, 20-40 VA max.
Wire rings install#
The Jumper Cable bypasses and disables your existing doorbell chime and must be installed before you can install your Video Doorbell. If you are uncomfortable or inexperienced, consult a qualified electrician. If you're not sure which breaker controls your doorbell chime, turn off the master breaker for your home or contact an electrician.ĬAUTION! You'll be working with electrical wires during the installation process.
Wire rings plus#
Permits plus professional installation may be required by law. Refer to your local laws and building codes before performing electrical work. Installation by a qualified electrician may be required in your area. Always use caution when handling electrical wiring.
Disconnect power at your circuit breaker or fuse box before beginning installation. Video Doorbell Wired is not compatible with the Plug-In Adapter (1st Generation). If it rings, your existing doorbell system is working.įollow the sound to find your chime and make a note of the location.ĭon't have an existing doorbell? You can power your Video Doorbell Wired directly using our Plug-in Adapter (2nd Generation). Ring your doorbell and listen for the chime. Your Video Doorbell Wired gets its power from the doorbell system and is designed to replace an existing doorbell button. Make sure you have all the required hardware included in your package:
0 kommentar(er)
